Accuair E-Level Ride Height Sensors Placement

[1badman]

dose any one with a srt8 300 have accuair? or eleveler? with out any lights coming on the dash ?

[Big D's R/Ts]

oh okay, I thought there was a guy on here that messed his ride up by the e level system failing on him on the freeway?

If a sensor fails it flashes red on the controller and the system goes into manual mode, the car will not drop to the ground. The only thing that would cause that would be a bag blowing out, and possibly a loss of power (voltage to unit) or a catastrophic loss of air at the tank,D

[UniversalAirSuspension]

i have a 2013 srt8 300 and i see your removed the factory ride hight sensor. i just put the accuair eleveler set up and i am looking for placement options with out removing the factory sensors. i also cant get it out of sport mode anyone have any good ideas

You should not remove the factory sensors. You will need to mount the accuair sensors so they will be a stand alone sensor.

the above pictures are some possible mounting locations that won't interfere with your oem sensors.

[Big D's R/Ts]

This is how I did the front sensors,I had to mount mine a little differently due to the SPC UCAs which required a small tab to be welded on. In the rear there is pretty much only one location as shown earlier,D

Tab on control arm

Mounting bracket on frame

[gabbas]

my elevel sensor mounting...
fronts-
i mounted the front sensors low.. and connected the pivot to the lower arm.







Rears-
like fnkycld has said thiers only one place the rear sensors can go....

I know this thread is old, But I need to see these Pictures. I need to Remount my rear sensors, and looking for some guidance.

Thanks